Forsentek Co., Limited
Forsentek Co., Limited
Add to Cart
Features
Dimensions(unit in "mm")
Specifications
| Rated capacity | 50kg 100kg 150kg |
| Rated output | 2.0mV/V |
| Excitation | 5-15V |
| Zero balance | ±2% of R.O. |
| Nonlinearity | ±0.05% of R.O. |
| Hysteresis | ±0.05% of R.O. |
| Nonrepeatability | ±0.03% of R.O. |
| Creep(30min) | ±0.03% of R.O. |
| Safe overload | 150% of F.S. |
| Ultimate overload | 200% of F.S. |
| Compensated temperature | -10...+40oC |
| Operating temperature | -20...+60oC |
| Temperature shift zero | ±0.03% R.O./10oC |
| Temperature shift span | ±0.03% R.O./10oC |
| Input resistance | 380±30 ohms |
| Output resistance | 350±5 ohms |
| Insulation resistance | >5000M ohms |
| Ingress protection | IP65 |
| Material of element | Alloy steel |
| Cable | Ø5*2000mm(Longer cable available) |
| Wiring code | Red--Exc+ Black--Exc- |
S beam load cell is known as s type load cell because of its feasured s beam structure,Rod end load cell FSSD is able to measure both tension force and compression force.The sensor can convert load or force acting on it into electronic signal which is proportional to the applied force.The acting force causes deformation of the measuring element,the bonded strain gage deforms accordingly which will cause the resistance change of the wheatstone bridge,under constant power supply,the output signal between Sig+ and Sig- will change proportionally,thus the load/force can be measured by measuring the output signal from the load cell.